由于一个是PATA（IDE）而另一个是SATA，因此您需要进入BIOS并在那里手动设置主从驱动器。如果两者都是PATA（IDE），那么您可以使用硬盘驱动器上的跳线开关来设置主/从。

Since one is a PATA (IDE) and the other is a SATA, you will need to go into the BIOS and set the master and slave drives manually there. If both were PATA(IDE) then you could use the jumper switch on the hard drive to set master / slave.